Technical Specifications

FAQ

1. What is the Schneider Electric ATV610C13N4 used for?
The ATV610C13N4 is a high-power variable-speed drive in the Easy Altivar 610 family. It is designed for controlling three-phase motors in applications such as pumps, fans, compressors, conveyors and industrial process equipment. The drive provides adjustable motor speed and torque control and is particularly suitable for applications where reliable and efficient motor operation is required.

2. What motor power is supported by the ATV610C13N4?
The ATV610C13N4 supports 132 kW / 200 hp in Normal Duty and 110 kW / 150 hp in Heavy Duty operation. Normal Duty is generally used for loads with moderate overload requirements, while Heavy Duty is intended for applications requiring greater overload capability. Motor selection should also consider the motor rated current, load characteristics, acceleration requirements and operating cycle.

3. What power supply is required for the ATV610C13N4?
The drive requires a three-phase 380–460 V AC supply with a frequency of 50–60 Hz ±5%. The installation should include appropriately rated upstream protection, disconnecting equipment, grounding and power conductors. Because the ATV610C13N4 is a high-power drive, the incoming power system and short-circuit protection should be properly coordinated with the drive’s electrical ratings.

4. What are the output current ratings of the ATV610C13N4?
At a nominal switching frequency of 2.5 kHz, the continuous output current is 250 A in Normal Duty and 211 A in Heavy Duty. The maximum transient current can reach 275 A for 60 seconds in Normal Duty and 317 A for 60 seconds in Heavy Duty. The actual operating current should remain within the selected duty rating and should be evaluated against the motor’s rated current and load profile.

5. Which motor control modes are available on the ATV610C13N4?
The ATV610C13N4 supports Variable Torque, Constant Torque and Optimized Torque control modes. Variable Torque is commonly suitable for centrifugal pumps and fans, while Constant Torque is better suited to applications such as conveyors and equipment with relatively stable torque demand. The Optimized Torque mode can be used where the motor control needs to be adjusted to the characteristics of the connected load.

6. Can the ATV610C13N4 be integrated with a PLC or automation system?
Yes. The ATV610C13N4 includes Modbus Serial communication for integration with industrial automation systems. A PLC or supervisory controller can use the communication link to exchange operating commands, speed references, drive status, monitoring values, alarms and diagnostic information. Communication parameters must be configured consistently between the drive and the master controller.

7. What should be checked when the ATV610C13N4 reports an overcurrent or overload fault?
Start by checking the motor nameplate parameters programmed into the drive and confirm that they match the actual motor. Then inspect the motor cable and terminals for phase faults, ground faults or loose connections. The mechanical load should also be checked for blockage, excessive friction or an abnormal increase in torque demand. If the fault occurs during acceleration, review the acceleration time and load inertia; if it occurs during deceleration, check the deceleration settings and braking conditions.

8. How should the ATV610C13N4 be commissioned after installation?
Before energizing the drive, verify the three-phase power supply, protective earth, input wiring, motor U/V/W connections and control circuits. Enter the motor nameplate data accurately, select the appropriate Normal Duty or Heavy Duty application, and configure the required motor-control mode, frequency limits, acceleration and deceleration times, and protection parameters. Perform an initial low-speed test to verify motor direction, current and operating response. After the basic test is successful, verify Modbus communication, control signals and machine interlocks before progressively increasing the load to normal operating conditions.